INITIAL ADVICE
Please ensure that you have read the instructions and are operating the equipment accordingly.
Check aU cables to your speakers and other components for any loose or incorrect connections.
Ensure that the rest of the components making up your system are operating correctly. A fault can
occur in another component or connecting lead that might appear to be a Xeta 2 problem.
Make use of the status infomration on the On Screen Graphics by switching the Display on via the
remote handset. The infomration will tell you what modes the Xeta 2 is set to.
If any problems stiU persist you may find the following suggestions usefid.
If you still have problems after carrying out the checks Hsted then contact your Arcam dealer or use
our helpHne number shown on the inside firont cover between 9am and 5pm BST.
SYMPTOM:
FAULT FINDING SECTION
SYMPTOM:
THINGS TO CHECK:
NO SOUND OR FAINT SOUND
• Are the speakers cormected correctly?
• Is the source you wish to listen to cormected and operating correctly?
• Is the correct input selected?
• Is the unit switched on and the POWER fight green?
• Is the volume turned up?
• Is the MUTE srvitched ofi?
• Is the TAPE MONITOR switched out?
• Is the amplifier driving the fi"ont speakers turned on and the correct
input selected and its volume turned up?
THINGS TO CHECK:
SYMPTOM:
THINGS TO CHECK:
ADVICE:
SYMPTOM:
ADVICE:
SOUND FROM CENTRE AND REARS ONLY
• Is the amplifier driving the front speakers switched on and the
correct input selected?
• Is the volume on this amplifier turned up?
SOUND NOT COMING OUT OF REAR SPEAKERS
• Is Dolby Pro Logic selected? The relevant LED should glow green.
• Are the rear speakers cormected properly?
• Have rear speakers been switched on (via the remote)?
• Are you replaying Dolby Surround encoded material?
• Has the rear volume been turned up?
• Is your source operating in stereo mode?
Even on Dolby Surround encoded material, sound does not come out
of the rear speakers all of the time; the amount of rear level also varies
from film to film.
SOUND COMING OUT OF REAR SPEAKERS WHEN
MATERIAL IS NOT DOLBY SURROUND ENCODED
There is nothing to check here. Sometimes on normal broadcasts
phase differences in the recordings can confuse the surround steering
circuitry allowing certain signals to be heard from the rear speaken.
You can of course switch off the rear speakers using the remote
control handset, or switch the Xeta 2 to stereo mode.
SYMPTOM:
THINGS TO CHECK:
ADVICE:
NO SOUND FROM ONE LOUDSPEAKER
• See points fisted above.
• Is the balance control set to centre position?
• Is the input balance set to L=R (via the remote)?
For the centre charmel: ensure phantom mode has not been selected
in SET UP MODE.
For the centre or rear channel: ensure these are not switched off via
the remote. Also try adjusting the channel volume.
To check a source component, swap the phono leads over (L -with R)
at the source equipment only. If the fault changes over to the other
channel, then the fault is in the source component.
SYMPTOM:
THINGS TO CHECK:
NOTE:
UNABLE TO MONITOR VIDEO FROM THE XETA 2 ON
YOUR TV
• Is your TV s-witched to the correct AV input?
• Have you connected the TV correctly to the video MONITOR
OUT socket on the Xeta 2?
• Have you selected the right video input via the source selector?
• Is the Xeta 2 properly switched on?.
If you can monitor the video signal but cannot display On Screen
Graphics then press DISPLAY on the remote to switch them back on.
12
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales